LQ-HF METAL DECORATING OVEN

Technical Parameter：

l  The equipment is mainly used for metal sheet surface printing or coating after drying, the whole line mainly by the conveyor, feeding device, drying, cooling, unloading, stacking composition. The main heating energy can be applied: electricity, city gas, liquefied petroleum gas, natural gas, diesel oil, kerosene, coal can also be used in a variety of energy sources, such as hot blast stove.

l  The imported PLC and frequency conversion controller are adopted to realize the shaft less drive to ensure the synchronization of feeding, printing, unloading, receiving and conveying.

l  Front and rear transmission is closed, beautiful appearance.

l  Discharge protection, conveyor chain tension, metal sheet alignment are used to achieve pneumatic control.

l  At the same time, the transmission part of the iron adopts stepless speed change, and the vacuum adsorption and the servo system are used for buffering, so as to ensure that the metal sheet is not damaged when being transported at high speed and dose not scratch.

l  E-magnetic stacker can be high speed more stable less noise.

l  The sliding guide rail is used for fixing, so that the hot and cold can be stretched freely.

l  The conveying chain sliding wheel dose not need lubricating oil and can run smoothly.

The temperature of each temperature zone is convenient and uniform, and the fluctuation is small.

Technical Parameter：